Sonar XL Control Surface w/Roland XP-10

Discussion in 'comp.music.midi' started by Pekka Leppaluoto, Aug 21, 2003.

  1. Hi,

    I'm not sure if this is the appropiate group...

    I was reading a tutorial on Twelve Tone Systems' web site about configuring
    "Control Surfaces". I own a Roland XP-10 synth which has a specific button
    (SEQ Start/Stop), which sends the following information (obtained with oBd
    Software's Midi Monitor) when pressed sequentially:

    "FA 00 00" (Start)
    "FC 00 00" (Stop)

    The question goes like this: How to congifure these two messages to "Play"
    and
    "Stop" the sequencer in Sonar XL?

    PS. I've loosely experimented with the "Learn"-button without any success.
    Sonar's midi monitor in the system tray recognizes these two events.

    regards,
    Pekka

Share This Page